The connecting pin is the master piece holding the cubes together. Our connecting pin is made to join a sliding nut which slides over the cubes, this way giving the whole structure a superior resistance; better than any other similar type of dock straping systems on the market. (boxes of 25)

* Also available in beige #LK 703021B

Bumpers are used to offer an additional protection to boats boarding the dock. Our bumpers have a vacuum valve allowing you to adjust the pressure in it. We recommend the use of bumpers which should be added to every 10 feet (3 m) in length. For example: a 25 feet boat (8 m) = add 3 bumpers.

* Also available in beige and white

Cleat used to anchor your boat to the dock. We recommend using a cleat for each 10' (3 m) length. For example: a 25' (8 m) long boat = use 3 cleats. Our docks move all the time, as does your boat, thus avoiding any unnecessary tension on the cleats. However, when you expect severe weather conditions, we recommend to tie it directly to the ears or pass it through the exterior lug connector. Our cleats are made of highly resistant plastic but less resistant than metal ones can be. (boxes of 20)

Sliding nut that goes over one of the ears of our cubes and connects to the connecting pin to form a structure. (boxes of 105)

Candock's cubes are equipped with 4 ears, positionned at various heights. Due to the space created between them, the spacer will be used to fill this empty space. Spacers are mainly used for the Jetslide's assembly. (boxes of 225)

This bolt is used to increase the overall resistance of the dock. Even if it is not required for the majority of docks, we still highly recommend it when your installation may be exposed to the worse conditions (e.g. strong waves, work platform, boarding large size boats, etc.). Note that exterior lug connectors are always required for Jetslide's installations. (boxes of 50)

The nut is connected with the exterior lug connector to form a structure. (boxes of 125)

This lug is used to fix the back tabs of cubes or corner cubes at the end of a jetslide. 

The connecting pin G2 is the master piece holding the G2 cubes together. Our connecting pin is made to join a sliding nut which slides over the cubes, this way giving the whole structure a superior resistance; better than any other similar type of dock straping systems on the market. (boxes of 25)

* Also available in beige #LK 703021B